Press brake film 

Together with the press brake tooling, we can supply additional units for sheet metal production shops and press brakes daily operation such as manual tooling for measurement (angles, radius, etc.), press brake bending film, storage cabinets, various holders, supports and adapters for different systems of press brakes to change from one to another.
The bending film and bending with the film is highly recommended for bending activities on press brake to fabricate the products with decorative or polished, ground, brushed, finished surfaces or with coating, production of kitchen and restaurant furniture, lifts, building, and interior panels, reduction of costs for post-bending preparation of parts during the fabrication process. The film could be used as it is with any tooling or press brake with manual positioning or usage of special holders to fix and rotate after consumption.

Why would you need it

• If you are looking for protection from scratches, marks and prints, and other possible surface defects during bending
  
• Your surface of the part is already prepared (ground or finished)
  
• For prepainted parts bending
  
• No additional work after bending
  
• Parts after galvanic treatment, plated or other coating applied
  
• Additional die protection
  
• Non-possibility of reworking parts (removing marks and other surface preparation is hard or impossible)

About our press brake bending film:

• Avoid leaving marks on curved panels
• Not applicable for workpiece rework
• No contamination of curved parts
• higher product quality
• Easy to operate
• Suitable for all molds